- Brake Lines
- EGR System
- cat/blitz help
- head torque
- taking off flywheel
- oil cooler on an n/a
- N/A Gas milage.
- Intake Help!!
- clutch problems
- Alright, so it's not rod knock, but get this!
- getting it started after head job.
- Starter Problem (Not a normal starter problem)
- head bolt torque specs
- leaking coolant
- knock sensor????
- power steering belt broke again
- Acis promblem from hell
- Q & A: MAFT Pro + 7M-GE - POST ALL QUESTIONS, COMMENTS AND PROBLEMS HERE!
- slow returning idle?
- standard rear exhaust (muffler??) length
- Fuel question.. did I do something BAD??
- torque converter question
- Still Having This shake!!
- Oil!!
- Weird code
- rear camber
- A couple quick questions regarding HG process...
- Oil pressure
- Shifting to reverse problematic
- correct oil dipstck?
- Idling RPMs get lower and lower
- diameter of standard exhaust
- Cam Gears
- Cranks but then suddenly stops.
- Head repair?
- Low coolant, but it refills itself.
- Fuel question
- Brake lights help..
- finally got it running
- Need help identifying the following part.
- O2 Sensor, Lower, CA emmissions
- Car wont start sometimes
- idle problems
- back in the supra thingy.
- Weird problem
- heater core hose
- bogging out
- Need some info on coil options
- nose cone differences
- need help desperately.(distributor Plug)
- ACIS and a vaccumm leak?
- Anyone have a deep sounding but quiet N/A?
- What?!
- How to install new battery terminals?
- Quiet Exhaust?
- problems with my 7mge
- Heater hose/waterfall sound
- Starter help please
- ps plate
- Leak *PIC*
- I have a Question
- Fuel Problems
- Need help...
- power steering problem
- code 64?
- where does each iscv coolant hose go
- throttle position sensor
- Bhg!!!!!!!!!!!!!!!!! 2day>>>
- help please
- Under Drive Pulley
- build thread......bhg
- No compression on cylinders 1&2
- Transmission Question?
- Does anyone here have interest in a header?
- converting a cali head to normal
- no idle
- catalytic project
- Alternator ground question
- VSV under intake manifold.
- exhaust hanger questions
- Apexi intake
- hopefully simple cat question
- Today sucked
- Wiring harness
- Weirdest thing ever. Sounds like rod knock but isn't.
- wires
- Throttle Cable
- hissing sound
- slugish, intermitent cutting out etc
- quick question
- HKS Super Drager vs a Dynomax Ultraflo
- knock or detonation
- moving gas needle
- TPS adjustment tips?
- Trim Pieces
- Backpressure?
- 1.2mm or 2mm head gasket?
- Tps help
- Test Pipe
- calling the na-t guys, need some help.
- what order do the spark plug wires go?
- 7M-GE Stoker?
- Highest Dyno Proven HP 7MGE
- will this clutch work
- R154 swap
- Help! Still have air bubbles!!!
- the strangest timing problem - i am stumped
- Nor-cal supra peoples help!
- Changed 7m rebuild questions
- Tech Posts
- antifreeze leak
- boosting a GE
- my speedometer is off by a guesstemated 15-20mph
- EGR on JDM 7M-GE swap
- I need code help please.
- Maft Pro with MAP setup, setting with a 550cc & TB Q45 Need it!
- head gasket done, car feels slower
- starting problem
- help after head gasket
- fluxuating r.p.m needle
- help me pass emissions
- cylinder head problem!!!
- Check engine
- a few NA-T questions
- What distributor do I use?! What do I have? Pix within...
- Catalytic Converter Test/Replace?
- NEW INFO! Problem with fuel injectors! Please HELP!!
- Lets Talk about Grounds
- how hard is it to convert a m/t 87-92 supra to a turbo
- Can it be a BHG?
- pressure regulator
- NA retorque answer ASAP
- ecu problem or something else
- HELP! failed smog twice!
- Help settle an argument! help mods, easy answer
- help! fast! tranny wont engage in RND2L
- vacume lines
- After JDM 7MGE swap, no fuel (new pics added)
- whinning/ screeching sound????
- tired of cleaning my back bumper
- hose and connector diagrams?
- Shims???
- 7m to 7mgte
- Heating and cooling,
- hopefully an easy question
- wiring scematics,
- LPG (propane) Carb options.
- Exhaust help...
- N/A w/ r154
- 7mgte motor removal and replacement
- intermittent sputter??
- Still need exhaust help...
- airintake chamber
- swap, and wont start
- Satanic A340E!
- Motor swap and engine doesnt want to turn over...wtf?
- oil pressure
- Intake Question
- unknown leak
- Lilse spring compressor tool
- bkack smoke and gas
- Measuring cam degree by piston movement??
- help i dont know what to do
- excessive gas consumption
- flywheel inspection cover
- codes 24 and 51 having idle issues
- stripped exhaust manifold header
- valve stem seals
- car's been sitting for a year, what now?
- How do you put back together the 7M-GE throttle linkage aseembly?
- Issues with electrics, possisble ECU or Harness Problems
- power steering
- speed sensor part 2
- Fog Light
- checking the fuel pump, Fp and B+ = spark aaahhhhh
- strange sound
- fried rings
- How to check fuel pressure regulator?
- Raspy Exhaust
- just wondering...
- post pictures of your hard pipe air intake
- 7M-GE Rebuilt Reliability?
- 7m-ge weight?
- Ignition will NOT turn engine over
- walbro on stock engine
- code 31 and running rich
- Swapping in rebuilt motor
- I dont F.N know
- Did the Head Bolt fault affect N/As?
- Spark plugs?
- 7-MGE PCV System
- Unknown Warning Light
- low idle.. car stalls if I don't keep on the gas
- t.s.r.m/efi system check procedure
- VSV??? Vacuum help
- Idle Drop/Stall with A/C on????
- Finally Finished!!! Woot!!! Thanks!!
- white smoke on start up
- guage location question
- need help just did compression check
- Fan Shroud
- afm
- Supercharger Kits
- 91 to 87 motor SWAP HARNESS PROBLEM
- oil pressure sender...
- Keep blowing EFI fuse
- had my sup weighed ....
- Here is one for the NA boys, Hope you enjoy
- Possible to remove crank and not remove head?
- My last bit of denial before the HG Job.
- Exhaust System
- 7M BC264 cam timing
- Rebuild
- problem with my speedo gear
- Engine died while driving
- Jdm 7mge oil pan
- coolant pipe on back of throttle body
- Wireing harness
- supra dies while driving back from vegas
- Coolant in plug valley
- Compression Test
- Anyone want a real cold air intake?
- redlining at 3-41/2 rpm
- water temp gauge not reading
- why my 7m was burning rich
- crank pulley with junk motor problem
- Help! dont want to push start my car anymore..
- couple na-t questions.
- O/D light flashing 89 N/A Auto
- top end oil fix?
- engine harness part#
- Bhg...again
- Tough N/A 7M build suggestions
- car wont start when hot
- cam gear questions??
- 7m-ge Intake runner dimensions
- 7MGE distributor magnetic pickup for MSD
- voltage drop?
- Occasional sputter
- Newbie from Columbus, Ohio may have messed up my air flow meter.
- Stupid Horn
- brakes won't bleed :(
- Burnt Oil Smell??
- High Idle (2k-4k rpms)
- car is redlining at 4500rpm need help
- Who sprays their NA?
- skid control
- no.1 speed sensor
- dip stick housing
- will the tems still work wit strut bars?