- wow
- Rear main seal problem
- codes 31 & 24, but won't start
- Chokes when hot?
- maintenance. have some ?'s
- the waterfall=fail!
- harness
- lighter
- The N/A Maintenance FAQ
- 1 easy question for everybody but me
- transmission fluid change
- Birdcage of Doom...
- Starving for gas
- Spring is approaching, and have a few problems to deal with
- types of tranmission fluid
- code 14
- I NEED HELP FAST! WITHIN 45MIN I'm Selling my Supra!
- oil pan?
- weird shuddering/rough startup/bad gas mileage
- Gas pedal feel and sensitivity
- Different throttle bodies
- Ebay Engine kit...foney?
- Brake Shoes and Spring Kit
- Over Heating
- EGR Block off plates
- More Power for My NA?
- argh possible vac leak again
- High temp RTV????
- power steering air control valve.
- anti-seize
- fixed idle problem
- Overheating
- Stripped Head bolt
- power window failue
- Coolant Reservoir Tank
- starts but wont start again
- need to find??4 my new project
- So N/A guys, what exhausts are you running?
- Presents from a friend
- source of oil burning?
- engine swap
- car almost stalls randomly
- Thinking about swapping.
- sluggish all the time
- Crank, but no fire
- weird electrical bug... related to fuel delivery
- rear end pumpkin.
- 7MGE 1/4 times - What are you getting?
- A little update on my 6M-GE ITB project
- Lets talk about head shaving
- Head gasket warnings?
- ordering clutch next week
- Cleaning out the MAF flap
- Constantly have air in my cooling system
- Having problems with distribor, timing is off!!
- fuel line banjo golt size?
- better spark plug wires
- Is this HG going to be ok?
- coolant on spark plugs
- oil pressure
- Passed smog, but HC was fairly high.
- Performance coil - Any suggestions?
- BHG job questions....
- sup guys..more of your priceless advice needed.
- radiator hose problem
- Bhg
- 86.5 NA run with no oil...knock knock knock!
- Cam seal problem
- Rack & Pinion
- wont start when hot
- JDM 7M and Oil Pan/Sump Question
- Three Bond Sealant 1324 for Drain Plug
- Braking Problem!
- freeze plug? major problems need help
- queery about testing sensors etc
- Question about my supra.
- Oil Change Surprise!
- the gap
- We had exhaust manifold/header design. How about intake manifold design?
- The fan.
- Best way to tighten crank pulley bolt
- high idle, runs fine. low idle, misfire
- Rod Knock = thrown rod :(
- Stripped Flywheel Bolt
- camry air flow meter?
- General questions
- different injector
- Shaftmaster's one piece aluminum driveshaft
- Tail lights, Dash lights Side marker and CC lights not working.
- I am a little confused on distributor install.
- 7mge remove emissons stuff possiable issues?
- Headbolts
- codes
- FYI -EGR Passage way blockage
- vaccum
- building 7m-ge to a turbo
- Cressida Owners: Steering knuckles, how much different to the Supra?
- engine specs
- A/F Ratio gauge install
- Overheating.
- Coolant Temp. Question
- My ITB setup is finish...Ready to mount!
- n/a high rpm build
- Where does this go?
- BHG?,Valve seals? carbon build up
- Will a 92 engine harness and ECU work in an 87
- 7M-GE Head weight?
- Clutch disc
- BHG Crew... SOUND OFF!!!!!
- Fel-Pro head gasket?
- Increased max rpm - need to adjust timing?
- help with n/a on turbo electronics.
- Rebuild vs. Re-ring vs. Replace with used engine?
- Clutch question
- Sounds supercharged!? Help!!!
- transmission
- Picture request- w58 clutch disk
- Oil In Spark Plug Gallery
- auto speed sensor or not?
- Seriously needing some advice on cams
- Last of rebuild; won't crank
- I think i might have blown my HG (update: Confirmed BHG)
- 7mge-ge: use block drain or oil pan for the ct 26 drain return line?
- Fuel Pressure Regs.
- power streeing pump help
- Jumpy Start
- Is #1 main bearing different from other 6?
- Car Wont Start
- Supra down
- Need Pics Help
- Engine won't rev past 2k RPM
- Flywheel bolts
- water banjo bolt at back of head thread size
- Distributor questions...
- Valve Cover Paint
- turbo 7m-ge?
- Cold Air Intake, Or Short Ram
- My ITB setup ...Now with filter :-)
- Throttle stop screw
- Slim in radiator...i feel a BHG coming upon.
- gte block with ge parts.
- won't start.starters fine thoe
- sweet deal?
- fuel leak
- check engine
- Flowmaster exhaust
- NA Nitrous?
- What is this connector?
- Should I stay away from this 7M engine?
- Supra Resurected!
- Car starts, but rough idle and white smoke
- seperating bulge on shifter
- oil leak
- rear pumpkin
- Finish with my ITB setup :-)
- throttle sensor
- 86.5 stock na hunting idle & stalling
- 7M-GE "Factory Refurbished" engine
- Pulls hard after 4000RPM
- proper name for hose
- Wondering about exhaust piping
- going T
- How much boost can a stock 7M-GE take?
- Best JDM engines?
- Turbo exhaust on NA??
- head gasket probs/opinions wanted
- engine locked up.
- Vac line issues
- Where does this connect..?!? (02 sensor)
- starter
- engine lock-up
- Confused on turbo return line.
- Q's about a 5spd tranny shifting?
- Oil Cooler ??
- Exhaust pops when RPMs decrease!?
- Resonator Delete
- Head Gasket Replacement Help
- Head And HeadGasket Questions
- How thick is the oem headgasekt?
- need help with possible n/a-T conversion
- Things I should know?
- Na engine bay shots!
- power from a NA 7m
- running rich, Fuel Dampener thing broked?
- 1jz/2jz vs 7m - quick question
- Best way to dyno a auto?
- whats do i need to turbo a 7mge
- types of head gaskets
- 87 supra non-turbo catback
- 7MGE Rebuild
- cylinder head locked
- 7M-GE/W58 weight?
- How hard is it going to be?
- knock sensor question
- Emanage Ultimate 7MGE AFM Delete
- intermittent issues - trouble codes thrown
- Wierd electrical happenings
- Fan Clutch
- head boltS
- help... clutch issues
- Exhaust setup thread.
- Head Bolt Order?
- Missing on #5 and #6 at low rpm
- Just what I've done in the past couple weeks.
- engine bay, before and after
- Cam Timing Whoops
- VTA-E2 Voltages/Resistance
- small problem....
- AC Issue
- New video off my ITB powered celica supra :-)
- gumed up cylinder head
- So close to finishing this BHG job.
- My car is a POS whats wrong with it?
- Oil still leaking
- half a bhg?
- auto tranny problems after rebuild. please help
- 7M GE Body with 7mGTE Engine, will the GE ECU Work?
- mhg. Where do I find one?
- Bvsv ??
- Post BHG - No start
- ARP install help!
- ITB Build for the 7M-GE engine!
- knock sensor!!!!!
- My brother is a jack-ass, help
- Wiring Harness Diagnosis...Repair/Replace?
- Thrust Bearing Install
- having a big shake!!
- curious about the TEMS
- No Spark for my 7M-GE
- i need help
- Quick Question
- having a bad run of luck....need to vent!
- cylinder head bolts
- Bit of a vacuum question
- Thoughts and ideas on an intake.
- Missing Power on lowend
- Headers
- Hard to start when warm, after BHG job
- overheating? no water?
- Bad words....
- Baffled
- Symptoms of a bad MAF and Intake Manifold Gasket leak
- What now???
- Please help guys, do I have rod knock?
- internal Distributor leak
- fans supposed to run after engine is shut off?
- cleaning the fuel rail and injectors...
- California ECU to non-Cali ECU...
- Last Help Thread, lol
- slight hissing