- Leaking coolant from under CPS and above manifold
- car dies on decel?
- CPS Causing miss
- torque specs are there for a reason
- Lex and 550s Questions ??
- Can I use a transmission oil cooler instead the cooling line in the radiator?
- Loose Gas Pedal?
- Fireproof Insulation Problem
- Oxygen Sensor question
- My swap.
- Can I use a w58 Spedometer cable for R154
- Random misfire on acceleration
- Tookwik's c.o.p. mod
- The new clevite bearings
- Plagued with Valve Cover leaks, Any Ideas?
- Won't idle, won't rev past 2700 rpms
- Gearbox problems
- Need some help
- SS Braided Line Kit (CT26)
- bog at max boost....
- No boost (turbo won't spool), low idle
- JDM 7mgte
- turbonetics HP66
- Oil cooler relocation
- New motors sitting and fogging oil? Expert opinions needed
- Whining sound under boost.
- what am i missing?
- Need some help from the EXPERIENCED for 500rwhp!!!
- Name where this goes/hooks up!
- School me : EGR - Where is it?
- HELPP! BAD misfire and going WAY lean at idle.
- strange new issue, rich shut-off (long read)
- BOV not a good Idea...
- TPS differences turbo and na??
- Running a 7M without the Coolant By-pass Tube
- MKIV TT oil cooler on 7M-GTE?
- Firing on 3 cylinders
- CPS Question
- Apexi SAFC keeps resetting to factory setting
- Early 89 harness in a 86.5..................
- Turbo oil feed leak??
- Where does this go?
- T4 Turbo oil drain into Pan ok?
- Oil cooler upgrade options opinions
- Testing the cam position sensor
- oil pressure sender
- Does any company sell a 2.5in IC pipe from the turbo down?
- All head parts got mixed togheter?
- Warm up time with new toyota thermostat.
- Bleed vs Gated boost controller
- Union Bolt Tap
- so here's what im doing so far...what do you think?
- New better? 7M manifold design?
- car bogging in low rpms and take off
- 7mgte hp?
- Car Won't Start
- shredded timing belt
- Grounding with Stainless
- Boost Sensor Wiring
- fixed ignitor, new issue!
- Lexus afm?
- Fuel cut with gt35r
- Fuel cut on lex afm+550's
- .20 over or .40 over pistons.
- missfire during acceleration
- Clutch issue
- Boost leak and starter question
- Starting problem need help!!
- Q45 Throttle Body Leakage - Anyone Else
- Ebay T4 manifold..will i need a turbo spacer?
- Anyone Know Where My Spark Went???
- o2 sensor wire diagram??
- BOV question
- Adjusting aftermarket camshafts - 7mgte
- Bad idle when cold
- Idle Randomly High, Other times perfect
- Maft pro timing control
- Black Felpro valve seals
- Splattering/Missing under load >10 vacuum
- crazy idle problem
- code 22
- Code 12 - no rpm signal
- Boost Problems
- Confused on Deck Height
- link cps install pic please
- Can i use a 7mge distributor w/ honda coil into 7mgte
- gas tank vent
- help with code 31
- Fueling Issues
- 2-step
- i need help. car wont rev
- Bov question....
- Will my HG seal?
- Wiring Harness of JDM engine too short
- egt question
- To cap or not to cap (PCV related)::Leak down 10/24/09l::
- Fuel Pump Question
- Code 22 diagnosis
- Breather line?
- help!! :piston ring gap: help!!
- power
- Bosch/Tial/something bov replacement kit?
- circuit opening relay
- question
- Tap or Helicoil?
- Stock Turbo Specs?
- catalytic converter questions
- will not rev over 1800???????????????
- Oil inside IC pipe and near turbo manafold
- Whats a good clutch for 550hp?
- supra in trouble
- install fmic
- Supra won't start after mojar rebuild.... Help need
- cam bolt sequence
- Starter wiring question?
- Dumping ALOT of white smoke at idle only. HELP!!
- New to the 7MGTE + Intro
- Cross swapping motors from different years
- Lexus AFM and 550's
- pistons&rods?
- Pre-89 SAFC Wiring Install
- Dual stock BOV
- Good battery drained by car
- Coolant leak from where??
- FPD Eliminator Install Question
- Silicon On Gaskets?
- Greddy Front Bumper
- non turbo starter on turbo trans?
- Options to route wideband harness into cockpit?
- turbo question
- Need a straight honest answer about HG's
- 4.3 diff / oil pressure level pressure question.
- Coolant Hose Under Thermostat
- Mookeeh bov
- KS rewire, the DIY link never works...
- block pitting
- Running Rich, even after warm start up.
- BOV question...
- Vacuum Trouble
- In what order do I wire a VPC, EVC, SAFC2 and Zeitronics wideband?
- Max Psi on 57 trim
- Breather line
- gt35r Turbo
- Wrong firing order?
- Boost changed after oil change
- ide problem and three diff codes
- Failed smog test
- speed control actuator?
- Code 31, 34, and 52 question
- Hks intercooler
- sputter sputter die
- Quick Help (ISC Valve)
- Antilock code 34
- Code 41 & 51
- clutch master question
- Car wont start - has zero power
- Need thread diameter/pitch of heater union pipe
- 50 mm hk$ wastegate fitment
- seals and gaskets
- Rack & Pinion Woes
- auto to manual swap question
- JDM ECU? yes no?
- tire size suggestions 18x9 front 18x10 rear
- Is this ok to do?
- coil pack wiring??
- IAC/ISC Valve Issue
- Vacuum for 7mgte
- hard to get past 13 psi
- A/F Fluxuation
- solved
- What are the basic mods you need done on a mk3 supra
- i need help!!!
- Anyone seen one of these?
- serpentine Belt ??
- building a 7mgte, going in a mk2 5mge. any tips, things i need????
- Quick question reguarding boost controllers vs shimming
- Straight Pipe?
- Bosch BOV Gone Bad?
- N/A AFM work on a turbo 7M?
- code 51??
- need help could my walbro be going bad?
- water out exhaust? BHG?help!
- Blown headgasket...
- BHG possible with no temp increase?
- help
- Help? No spark again... >_<
- Install advise.
- Not the normal Crank Pulley question.
- 7mge longblock replacement
- stall under load.
- AFM question
- Mystery Tap/knock. Video, can you identify?
- Phantom Misfire.
- 1991 7mgte starter issue!
- noob BOV question
- cylinder head porting / what is this for ?
- Need help identifying plugs on block
- 7M-GTE; Ticking noise.
- EGR cooler
- Motor Swap
- Question to the wise ones
- Stalling after replacing afm
- PFC F-CON 440cc 550cc
- Engine swap questions
- Timing Issues [SOLVED]
- Oil Return For T4 Turbo.
- Help please
- Ceramic Coating 7M Crank
- stalling after boost
- Decking block with timing plate
- oil is shooting up out of the dip stick tube
- code 41
- Strange Idle Issue
- Tps
- Need vacuum hose diameters?
- USDM 550cc Injectors with 7m fuel rail
- Boost Leak In Brake Booster
- The story of the bhg
- Stock 7mgte + 550/lex + 60-1 CT26 = ?
- Spun Bearing Why Cylidner #1, Twice now.
- ABS Line Lock
- Lifter Question...
- Headgasket Boresize
- New to the world
- Good Deal?
- Fuel Injector/Plenum Removal DIY?
- so what went wrong here?!?!? Please help.
- valve stem seals
- Rpms drop at 1700rpms
- fuel pump problems
- Another BHG Question
- Damn-need quick help again!! Won't start
- in need of help code 31
- Oil pressure issue/and a battery issue..
- Engine harness question
- weird noise past 4500 rpm's
- Proper way to perform coolant flush?
- r154
- na cams
- Somethin's messed up
- starting problem
- Cooling Fans
- Quick Q?? How much does a 7m-gte head weigh?
- Vaccuum line
- well i diagnosed, 2 codes
- Has anybody used this CT26 rebuild kit?
- Knock Noise @ 1900 RPM??
- missing Ignition
- 7mgte wire harness 5spd
- Engine swap - name that part / harness