- headgasket
- vac ports on TB vacuumless?
- Solid mount problem
- Help with code 71
- Injection Duration Monitoring Directly from the TCCS?
- altitude and timing
- got head back from machine shop with notch in it
- Power Steering Braided Line Fittings
- limited slip???
- 625rwhp tear down part 2
- Help!! Tail lights dont work
- code 42,43
- afm screw
- Help Identify Coolant leak near front of engine
- IC piping HOT. bad?
- vafc... install wiring???
- TPS inspection per the TSRM
- Cylinder head retorque
- car is burning oil on start up?
- r154 flywheel bolts
- code 22
- Which gasket maker to use Please Help
- What thickness oil do you recommend?
- turbo cylinderhead on n/a
- sitting afpr?
- Custom PCV line near oil cap?
- thorttle cable adjustment?
- Afm?
- Oil pump driveshaft retainer broken
- headgasket spray with felpro?
- anybody done a non toyota 5spd/6spd swap?
- all boost but no power...help!!
- CX Racing Turbo?
- Loosing coolant....Need help?
- cam postition sensor question
- Need Pinouts for the Body Harnes on an 87T
- Question here!
- water pipe behind exhaus
- Having problems running please help!
- Piston carnage
- Did i install my blow off valve right?
- Overheating help needed
- timing!!!
- where to find a ct26 exhuast header housing flange
- Probs with Vacuum Lines
- aeromotive fuel pressure regulater info
- turbo soft line length
- pretty sure turbos dead
- benefits to electric fans?
- engine lacking power
- Crank, No Start!
- Knock Sensor Issues
- losing oil somewhere?
- O2 sensor wireing
- Wiring prob - 7mge - 7mgte.
- 7mgte code 51 messed up idle runs rough
- MHG to Cyl bore difference
- Where to purchace rebuilt shortblock
- 7mgte valves-cams??
- vaccum nipple
- Not sure if this is fuel cut or not
- ct26 rebuild kit 60-1
- 7M-GTE, Vacuum; Where does this go?
- replacing clutch 'n stuff - pull engine?
- What is this vertical scratch?
- HUGE eletrical problem, on new rebuild. no power
- jz manifold on 7m
- Muffler db ratings and hp levels
- What is this step for?
- thread lock on arp studs?
- A few issues regarding timing
- slave cylinder question
- Piggyback suggestions??
- Bearing Clearances
- Dashpot mod: to solve engine stalling when venting BOV to atmosphere
- Alarm / brake light
- Vacuum line Q's
- Plug Info
- Wastegate Question
- where to buy flywheel (stock?)
- 7M-GTE; Won't idle longer than 20 sec.
- no start after re-torquing head and changing cam seals.
- part# pocket guide
- oil pressure sender hole
- Violent shake/clunking. Bogs down RPM's. broken/loose bolt?
- oil smoke off the manifold HELP!
- PCV system/ explanation and mod
- EGT readings
- Reusing oil pump?
- wreck, price check please
- CHecking BOV for goodness...
- Blown head gasket question
- Where to buy JDM 7mgte motor
- I need a quick rad to gnd verification.
- climate control problems
- Help; excessive crank case oil pressure
- ignition timing issue
- Future turbo 7m
- Compression Check Results
- Reusing Pistons for rebuild?? Boost controller?
- Valve buckets & shims got all mixed up (Stupid red squirrel!!!!)
- Cracked Head vs BHG
- Bearings anyone?
- Blue Smoke /Burning Oil/ Turbo Bad?
- How hot does the heat sheild get?
- OOPS! Need help hardwiring the CPS ASAP!!
- 6m/7m crank visual differences?
- What BOV should i go with
- wireing harness swap????
- Do I need ARP rod bolts for my power goal?
- I give up! One for the experts..
- Code 25, running Lean.
- O2 sensor wiring
- Well got the "supposed" GTE apart, someone killed this thing...
- custom adjustment screw lexus
- t3-t4 adapter question
- Can I make a swap to a 7mge to make it 7mgte
- Why use higher pressure radiator cap?
- spark plug question
- changed plugs, runs rough, then dies??
- aeromotife fpr, what psi i should set it to?
- Oil Cooler
- stock fuel pressure regulator
- Higher than normal temp
- running lean
- excessive blow by, compression and leakdown results inside
- I"m tapping brake peddle, AF's go through the roof.(slight NWS)
- Exhaust manifold torque specs
- Bigger Piston 7mgte
- Are these Ground or Hot?
- camshaft position sensor
- ac compressor supposed to spin freely?
- Vacuum Line Question
- Glyptal
- Head Gasket thickness selection
- chassis electrical
- Mysterious Trans/Clutch problem. Now know what it is...R154 (new pics)
- Problem with steering at idle???
- Standalone on 7mgte
- My Oil Cooling System- Is this correct?
- preventing bhg
- No spark, no start after fuel and brake lines were replaced
- Engine struggles after Lexus AFM/550cc mod.
- EFI Main Relay
- Question about water wetter.
- Idle Issue...
- i think i'm ready to fire up the beast
- 87 turbo auto trany????
- Bad Idle and A/f after a full engine rebuild , Need Help.
- Camshaft positioning sensor??
- CPS Help.
- Gap the PLug !
- 7mge crank on 7mgte
- Aeromotive Regulator Install Pics please
- old air intake piping with mass air flow
- Inlet fuel line fitting size needed
- Location of anti theft deterrent
- Sticking 550 ND injectors
- AEM wideband install?
- Auxillary fans always on
- No heat... heater core coolant valve perma-closed.
- Interesting ECU Situation
- Gauges Not Working After Swap
- Arp Studs vs. Bolts..need advice
- half metal HG?
- turbo oil and pan
- Rod knock problems
- t70 or similar intercooler routing
- Fuel cut and wideband o2 location
- Knock Sensor code after all this time....
- PCV tubing size
- 86.5 Piston Rod Cap Torque Specs
- Coulpe t4 turbo questions
- is this normal?
- Cold start sensor
- what kind/thickness of head gasket to go with?
- need power steering hose diameters
- ddp on a BOSS turbo?
- Mystery missing problem
- car overheating??
- car died, won't start, no spark, code 12 & 14
- alternater relocation
- starting problem
- no engine hoist so...
- Acceleration H-E-S-I-T-A-T-I-O-N-!
- 91 Supra with Ignition breakup AEM and HKS DLI
- T-67 Ct26 upgrade
- For $600 MP t70 or PT 67mm
- Shimmed Wastegate?
- 1st build what did I miss
- converting from a 7mge to 7mgte?
- oil pressure and sender questions
- Help! My car doesn't want to run properly, and it's driving me nuts!
- code 31 only at idle? randomly
- 57trim fuel cut
- No nipple on turbo-where is alternative pressure source?
- Very strange situation with MAFT PRO. We don't know what is it.
- SAFC Neo
- Engine rebuild questions
- fly wheel q
- Stock Boost Gauge not working!!!
- code 14 with maft-pro timing control...
- rich or lean?
- ct26 + coolant in exhaust??????
- Wastegate not working...
- fuel line question
- Intermittent check engine light
- Requesting assistance with SSQV installation. (>^_^)>
- Motor ruined? Kinda a funny story...
- TPS? COUPLE questions supra newb
- GReddy turbo tach? - Stange!
- lightwheigt flywheel
- What is this hose? (pics)
- 7M-GTE torque numbers.. 80 lb/ft or higher?
- wiring hks fcd
- How did you replace your injectors?
- Wastegate sizing
- CT26 57 trim - safe psi?
- Head prep ????
- rear tie rods
- JT58 Series Turbo Questions
- pick a alternator
- Exhaust manifold gasket
- Car feels flimsy and unsafe
- intake restriction and stock lsd question
- got a Q...help
- block question
- temp guage rises and falls with tach
- Weird Progressive Acceleration Phenomenon
- some boost and ecu problems...
- need help!!!!!
- New 7MGTE Swap from japan
- miss fires
- 7M-GTE Combustion Chamber and Squish Pad Mods
- help? engine breaks up when in boost
- Psi before my bottem end blows? And JDM motors?
- denso 700cc injectors
- issues after changing out spark plugs and valve cover gasket
- Boost and no go
- intermittent missing...wtf?
- help on oil pressure gauge
- engine pics
- Name that part
- Rediculous, My new turbo fits on nothing?
- strange sound from tubo
- Code 43 Diagnosis
- noticed block pitted while doing head gasket change?
- 57 trim ok to run on stock setup?
- Guess what i did
- BIC DDP fitment on upgraded turbo