- where to buy sycros?
- Some rebuild questions
- interchangeable parts 88 - 89+
- code 22 and 31
- Where does this hose lead?
- temp problem
- universal oxygen sensor
- Rpms going up and down???
- What are optimal readings to get on the TPS check in TSRM?
- Charcoal canister Vaccum Line????
- Slight Miss
- BOV Control Line?
- Breaking up.....neeed help
- installed new clutch, vibration problems
- Pics of 7Mgte
- boring 0.20 over
- Just got swap done, doesnt start?
- new headers
- Fuel cut off
- Coolant Leak please help
- Wierd electrical problem
- O.E.M/Factory .05 over pistons 7mgte
- My problems..
- transmission seals, how tough?
- another road block...
- No Groove on OBX Crank Pulley for Timing??
- Need to know which wire is which on ISC ASAP
- Aftermarket Fuel Guage
- Temp guage needle stuck
- HELP!! Power Steering
- Differences in throttle bodies?
- bleeding coolant system
- there is no mark on my cps help
- =( I think I may have rod knock... help?
- HELP!! Where do these parts go?
- Bad Miss, is it the CPS?
- Climate Control Module Question.
- Replaced Starter, now car dies while driving?
- Thread size on oilfilter?
- twin turbo 7mgte
- car is not starting
- Idle issue solved, but not?
- OBX cam gears
- disconnecting TPS when setting timing?
- JDM 7M-GTE vs. USDM?
- I THINK we have a problem. KS related (and no not about wiring)
- Code 22
- Turbo or Non-Turbo Intake
- Blow off valve experts
- Glovebox Stuck!
- HAC Sensor With VPC
- Turbonetics/Performance Techniques in CA.
- Auto to manual clutch pedal assembly question
- T4 Exhaust Manifold with External wastegate
- stuttering
- no spark to cylinder five two and three
- Timing issues.
- 8 injector clips?
- Jdm 7mgte swap ?'s
- safe boost level on stock ct w/ fuel and engine mods
- Expensive intercooler or cheap intercooler
- Oil leak
- I removed the cruise control
- starter repair.
- What's your guess on my ponies with these mods?
- what it takes
- is it safe to say my turbos dead?
- A/C removal and some other ?'s
- BOV what's the point
- I'm changing my timing belt and this is what I found. What does it indicate?
- code 51
- Dammit,oil pan prob...
- What could this be?
- Top end build
- modded or bored stock injectors
- code 71, 90 supra Ca Vehicle..help?anyone?
- Gas Milage fluctuating
- Will a 88 turbo harness work for an early 89??
- 4th gear fuel cut?
- trouble after driving
- Supra Waste Gate Size Turbo size
- new SSQV help
- Stock 7m-gte Vaccum in In/Hg
- Bov flutters badly.
- car acting wierd
- AN-10 oil lines....what am I doing wrong
- New Turbo, supporting mods?
- Lexus LS400 AFM Capacity and Limits on 7m
- Faulty EGR Valve
- is there any diff.?
- EGR removal...help?
- FFIM and EGR valve???
- Turbo oil lines
- 680cc injectors ok?
- Custom oil lines for CT-26
- Stock Exhaust Manifold bolt sizes for leak?
- Confusion about coolant leak 2nd time around??
- another curious question
- Supra Cam Gear Sprocket Location
- Need Help Planning Rebuild
- Major frustration adjusting TPS...Help?
- Siezed up tight!
- aem ems=no isc valve?
- anyone using synchronic BOV
- Erg bolts, Also Where OIL RETURN for turbo inside the block
- ebay turbo header, any ever cracked? (DON'T POST unless you have PICS!!!)
- HKS downpipe and 3inch elbow. (not gonna work?)
- ARP mains
- Torque Spec: for Drive-Plate to Crank
- Universal o2 sensors
- Oil Pan/Sump Huge Leak!
- AFM weird LS400
- Test Strips
- Helicoil stripped exhaust studs?
- Emergency: NEED CRANK SPRocket WILL Drive IN Michigan TO pick it up!
- How many houses can I get out of the stock 7mgte block and still be reliable?
- Crank milled at the ned Differet diameter.
- fuel problem
- dis-4 and stinger
- Q45 Tb Diagram?
- Turbo Details????
- every thing is running hot!?!?!
- Engine temp?
- What's wrong with my walbro :(
- what's this part called?
- Car feels faster at times?
- 7m-gte A/c Lines wires removed?
- Best software / placement for Lc-1
- EGR: Any Complications ??
- Bhg?
- boost cut
- Boost doesn't change using MBC
- springs
- Question about wideband 02 sensor
- Correct Oil Pressure
- EGR VSV clicking?
- Blitz FATT turbo timer wiring
- High idle, no vacum leaks
- She's Being Tempramental...
- head games
- what fits?
- Help Wont Idle When Cold
- 57trim on stock fuel?
- engine bogging down
- Cold start issue
- eh starting problem
- How do you tune the Brian crower cams for the Mk3?
- wont start, please help
- Oil pan gasket? or Permatex? lol?
- What causes valve buckets to not slide onto the valves freely?
- Overheating Q's...Chime in masters.
- ok i cant find it
- Taking off oil return lines
- Question about my now, "heat treated" block
- Cam Angel Sensor! Timing
- power loss please help
- ffim questions
- how do u know if the rings are seated
- super lean at idle
- 88turbo swap into 89 help
- Oil Cooler Fitting Size at Oil Pan
- ARP Head Stud Question.
- Starting/Timeing
- Electrical fun.... not lol
- how do i hook up my mbc?
- 7m-GTE MAx Boost ????
- blitz DSBC
- CT-26 Flange Dimensions
- wiring electric fans
- Rear Main Seal
- 7m-gte with 550's Do i need A FPR?
- Big problems help ASAP
- car dies after first getting out of storage and building boost?
- 5spd swap question, car is on lift......
- two supra questions..rear end, and idoling
- new motor
- no thermostat
- Power Steering too sensitive
- Corrosion on spark plugs in JDM engine???
- What guage are the fuel injector clip wires?
- HG questions
- How much boost is the walbro good for?
- dose size really matter???
- jdm shit motor
- Possible BHG?
- anyone ever seen this?
- Shimming the Waste Gate. Good or bad?
- One of these things is not like the others.
- engine light problem and boost cut when the light first hit
- headlight problem
- MAFT PRO *or* MAFT Gen II
- Fuel Regulator / VSV
- HELP! my engine warms up in reverse order
- Mysterious Illness of my 7m.....
- Rings Gap.....
- CPS re-wire questions.
- Valve cover screw problem
- show me your afm-less intakes
- brake system problem
- Injectors ??
- Common turbo flange dimensions
- j-tube advantage?
- Stock Colour of 7MGTE Injector Clips?
- cps question
- Greddy 52mm electronic boost guage HELP!!!
- turbo sensor plug
- Vexed by Cylinder Head Minutiae
- Spark plugs and oil.
- Setting timing problems
- Block machining question and long story
- Help!! I"m leaking Gasoline.
- So my car has a miss...
- Bogging down???
- idleing issues
- 7mgte Internal Wastegate Questions And (bov)
- HELP! Sensoe what one IS IT And WHAT DOES IT DO!
- 7m-gte ECU Perameters?
- Injector Style Fitment Issues
- What sensors are on the thermostat Housing
- VSV How ImPortant are they?
- What one is the start ground!
- HG Thickness
- EGR: Is it goign to blow cylinder #6
- Water rushing HELP
- 2 Step rev Limiter
- AEM EMS on 7MGTE...Strange!
- Starter + and -? Wires?
- annoying suspension problem
- Mines VX-Rom for 7mtge. Anyone know about it
- These wires: Where Do They Go?
- Switching to GM TH400
- need the wiring diagram for the safc II
- I'm a little concerned.
- Eagle rod install ?
- Can the 1jz Manifold fir on the 7m-gte?
- 7m-gte Fan Change good Idea?
- FAILED Cali Smog test...
- abolute most reliable upgrade parts for 350hp DD/weekend dragracing supra
- hks vpc and fcon and fcd help
- rear strut relacement, underway....I need some help
- GTE GE galley cover?
- No spark head rebuild
- stock mains for 400-500hp????
- Removing fuseable link.
- Charcoal Canister?
- Backwards battery
- Fuel Injector/Coil pack lines
- 7m-gte Stand alone Hel-Tech, Aem, mega squirt?
- oil pan bolts?
- Testing stock BPV for leaks