- Power steering woes (spitting fluid)
- car dies while coasting
- engine rod berrings question
- electrical starting problem
- Crankshaft pulley
- Checking for codes question
- My old crank, why did this happen?
- HELP!!! smog issues....california
- New Injector Time?
- Microtech?
- won't idle on its own
- replacing intercooler hoses, need some help
- Sputtering at Idle after change of sparkplugs
- Time for new spark plugs, will stock MKIV TT plugs work?
- Making sure I did this correctly! 56k warned!
- Time for a new motor
- Things i should be prepared for a smog check in CA
- can not find the leak
- rebuild
- ge clutch disc on gte? will it work?
- stock bypass valve question
- damn rivets
- Mitsu 20g?
- MAFT Pro!
- smoke coming from transmission
- Can someone please identify this part- Flush/Fill connector
- is oil dye green?
- Deteriorated master cylinder reservoir
- questions about nitrous
- Calculating the static compression ratio on a stock 7MGTE
- Diagnose: Rough Idle/Rev; Miss Under Boost
- Deformed aluminum T4 flange gasket
- need to find out if i can cross check the VIN with Engine block #
- quick question
- Crack in the stock downpipe
- Size of my rod bearing 88 Supra 7MGTE?
- Bit by the Supra
- what would cause this
- Question about intercooler
- screw or no screw?
- Fan Belts need changing time. Tips & advice appreciated
- Engine is Out Spec: making sure HKS
- MAJOR PROBLEM !!!???
- going back
- Sach clutch kit
- Lexus AFM?
- Anyone running these clutches?
- NA body with turbo engine cant get it to start
- hard to start... sometimes.
- HKS Fuel Cut Defender
- FUEL INJECTOR REBUILDING????
- Manual Boost Controller (MBC) DrJonez
- Motor is surging!
- HKS F-CON
- CT26 Removal
- does this sound like the infamous bhg???
- Low Fuel Light Stays On?
- new noise
- Safe A/F Ratios
- boosting problems
- Best AFR for the 7mGE
- My clutch is slipping. Which one do you recommend?
- Factory oil cooler lines
- oil temps?
- Problem dying after boost....cash reward!
- color of the coilpack wires on harness
- Undercut studs
- Test Knock Sensors
- M series interchangable parts guide?
- 7M-GTE AEM EMS Pinouts Help?
- Valve cover gasket
- NGK wires and NGK 6097 spark plugs wont fasten down?
- Strange problem inside my car
- 7M-GTE fresh rebuild-Low RPM miss
- How are Accel injectors?
- People with Drag Wheels
- High idle STILL, where to check into next...
- actuator bracket 4 turbonetics 60-1 ct26
- crankshaft removal
- I'm getting my head flowed. Have a question.
- 7mgte engine wiring questions
- help with R154 tranny..
- Choosing Exhaust sizes
- What Could Be Causing 'bogged Down' Acceleration
- Aftermarket CT26 Manifold
- Denso Injector Mystery
- FPR: Rising Rate or fixed?
- Engine Assembly Question
- hesitation in low rpm. problems w/ starter..?
- seized turbo
- Did i fry the wiring in my Cigarette Lighter wiring?
- bad ecu??
- battery hooked up backwards
- so i searched for real on this one..
- can you use the egr port on the intake manifold for a vacuum source
- NO Fuel Pressure
- Need Crazy help,. MAJOR PROBLEMS!!!
- turbo vs. n/a EGR valve?
- Code 12 leading to misfire
- strange misfire then code.. then no code
- they estimated head resurface 500$$$ 0.o?
- Don't grind the valve stem
- Oil pan drain plug sealing surface
- Water fall noise?
- Knock sensor rewire question
- Picture of knock sensor locations
- IS this the starter?
- fresh motor, no start?
- Starter
- dual port actuator
- unknown turbo... any ideas?
- gte -ge
- Wanted: Sound clips of a 7M-GTE running WELL
- Shotpeening rods
- 2JZ/7M FFIM Matchup...
- 7mgte engine light error
- Stock IC
- Rough Idle/FFIM
- OK MHG in motion, please check my check list, MODS...IJ
- busted diff? or fried rings??
- FFIM alt drop down, where to put a/c?
- Best Rods for 650hp?
- What's my boost safety/danger zone?
- tips on rod bearing repalce
- gasket question
- code 31&24 problems
- How to change out, exhaust housing from turbo?
- Where should I get a new turbo? eBay? Prolly not
- Bltiz Dc2 Turbo Timer
- supra jerking shows codes 34 and 52
- what kind of clutch disk is this ?
- Boost Gauge
- high temp coupler for exhaust?
- what should i do next?
- oil feed/drain to turbo on na block
- Don't you ever do this (Damn fool I am)
- Seat belt light stays on and how do you get this *&@$#@! air filter off!
- smoking need help.
- I hate valve shims
- Best trim size for Upgraded CT26 on 7M w/o changing fuel system
- i was joking
- 650hp gtk or t-series?
- what size intercooler are you running?
- oil in exhaust manifold
- Is the AEM worth it for 600rwhp?
- Whats this go to?
- Moly rings...
- how to start
- My machinist is scaring me
- replaceing clutch question
- Humming, blender type noise could that be wheel bearings?
- Need Help With Code 24 and Code 51
- n/a egr?
- What color is the pink speed sensor wire after the connector on 89+?
- $200 eagle rods
- Wastegate Actuator
- charge pipe size
- Torquing RPS stage 2???
- 550 cc injectors pressure question????help
- My problems thread. *updates*
- Crower Cam Group Buy 1st Batch
- Anyone else have surging issues with SSQVs?
- 7mgte head vs 7mge head
- Quick Vacuum question
- Knock sensors q
- Air bag light
- The dreaded goo
- How to install an electric water temp gauge with pics
- Timing belt?? help!!
- Any thoughts?
- Gray harness on an 87
- Code 12, revisited
- To rebuild or not to rebuild?
- E85 and Ethanol/Methanol. The ins & outs of AFR's
- Stuttering supra
- I need some help with my alternator plug
- Car won't idle/start after BC 264 cam swap from the dead
- Tensile strength of stock rods?
- 7m ecu
- start injector time switch needed?
- Failed Inspection Need Help Also Code 21
- Injector connnector type
- 90T-Rattling noise from block, timing issue?? Updated
- ct26 turbo seal help
- Dumped Antifreeze into Wiring Harness
- Water leak, trying to get the parts.
- Power Steering Belt Tension
- Code 25 and 26 caused by CPS?
- estimated horsepower with these upgrades
- ahg... that time in every supra's life-bhg
- 87-92 Block Differece 7m-gte
- Looking for 7M-GTE ex manifold
- Eagle rods have no bearing oil hole? wtf?
- Ideal compression ratio for my build??
- getting the new motor going..
- What Synthetic should I use?
- Cruise Control troubleshooting
- Where to buy the accordian hose
- screw appears to be missing. HELP!
- 7mgte swap with w58
- Boost Problem
- Gaskets for HKS Downpipe
- Q45 wiring!
- 87 mkIII supra HELPPPPPP!!!!!
- Help identifying a turbo size
- What 550cc Injector Choices Are Recommended?
- Rear bushing install problem??
- Turbo oil/drain line question.
- NEED HELP. AFTER INSTALLING BHG, now car won't start
- to run or not to run? Boss turbo
- Crankshaft thrust bearings (washers)
- I'm Stumped
- Exhaust size?
- error code 32
- Bosch Super Plus Coppers Any Good?
- Finally, after 9 years, Tial has redone their BOV...
- stock clutch power capabilities?
- Instant Rod Knock After Re-build - Oil to Bearing Problem?
- Help with the tranny!!!
- apexi safc2
- GReddy TD06 and GReddy Type S Surge?
- what vicocity oil should i use?
- fuel problem??
- cam / crank sensor setting?
- Full boost lose power!!!
- Can rod knock come and go?
- Supra won't start, and nothing electrical is working, please help
- Wiring problem
- will a 2.75 in coupler fit the TB?
- bc 264 cam question
- HKS SSBV no adjustment screw?
- which one of these clutches would you recommend?
- s13 radiator in mk3 supra has anybody done it??
- Bov Help
- Running richer than before fixing the original hoses that come from my cooleze intake
- I'm not lazy, I just need to know quickly! :)
- how to time 7m turbo
- Anyone have experience with Crank Scrapers?
- injectors wont open
- To retorque or not to retorque after 6K miles....
- Did a boost leak test and well, ouch
- consequences of not using torque plate.....
- need some help with my idle PLEASE!!!
- Tried the 12V fuel mod and failed somehow...
- Who rebuilds your Ct26?
- need shop for head work
- how can i tell if my ct26 is spinning backwards
- V Band Flange
- ZT2 wbo2 tps readings
- another misfire thread (poss injector related)