- Trowing CODE 34 after AVCR install? i have vpc.
- fuel pressure up vsv
- simple question about turbo efficieny and power
- sce copper head gasket
- Need help!!
- Stock CT26 Inlet size?
- WTF? Engine Rattling!?!?-not rod knock
- ARP head studs or bolts?
- brown shielded mystery wire
- Car Problems please help
- Is a machine shop in the forum?
- quick question. =D
- Fuel pump rewire diagram
- Using R154 without ABS on a car with ABS
- Automatic harness for manual???
- What's wrong with this turbo's description...?
- rod knock...where do i even begin???
- Tubular manifold
- Keys please!
- Drag Racing Suspension
- what exhaust should i get, 4inch is annoying
- ct-26 exhaust- what is the A/R?
- fan shroud... take it off?
- Who installed head with cam on arp successfully?
- what clutch??
- Fuel cut at low boost, very low boost!
- 7MGE and 7MGTE injector resistor packs...
- excessive oil pressure
- My car takes forever to start
- Fat hard heater hose
- Which color wires go to which injector (rewiring)
- intake leak
- Cracked Turbo Housing????
- i have a smoking problem
- Missfire at idle
- running lean when i turn elec. fan on
- my apex'i power intake
- i might get flamed but....
- Ebay Downpipes
- Pre89 lip still in existance?
- Oil filter relocation kit
- gauging interest
- blown turbo? or worse?
- something in my turbo??
- Oil Pressure
- turbo, upgrade?
- Head Casting Codes
- turbo replace
- BOV options
- Non tuning, simpler, CHEAPER version of Maftpro???
- How do i stop this crazy wheel hop business??
- Banjo bolt in back of head wont fit Please help
- vaccum lines
- Transmission upgrade / replacement?
- Something broke @ 18psi... lets have a contest!
- Found this under my car, what is it? R154/Engine rear mounting
- BRAKE LIGHTS NOT WORKING..
- HUH??? Found on ebay
- OH GOD.....NAME THAT PIPE
- oxygen sensor question
- WideBand installation
- Loss of power...trying to find boost leak
- Blue spots on crankshaft
- ISC Idle/Stalling Problem
- Knocking fresh rebuild "big pictures"
- 154 swap
- My 7M is toast! where to go from here?
- Going to get ass killed but exhaust question
- Fuel problem UPDATE*
- Lexus Electronics in a supra afm??
- ARP Mainstud Set???
- HKS PFC F-CON question
- VPC wiring
- Any HKS BOV maniacs in here?
- I just bought R154 and i have a hole in it, what goes there? pic
- compressor surge!! what to do??
- what gas do i use??
- help what to do next ???
- Fouled plug?
- injectors size for map ecu
- Timing confusion
- safc apexi neo
- inline fuel pump question
- ct26??
- Polarity matter for RC550 injectors or not?
- Bypass Hose
- Is this compressor surge
- Power Steering
- on the fence...maybe BHG
- no lights in gauge cluster
- Solder or Crimp - [injector clips]
- Cam gear - best sound
- TPS Adjustment
- Car wont start by key.
- boost guage
- a/f ratio
- ecu question
- glowing exhaust manifold
- Non-Tech looking for TPS Calib. Help.
- BC springs and retainers VS Ferrea springs and retainers.
- SAFC2 weird problem
- Holey advanced timing Batman!!!!
- oil pressure
- ONLY Idles with ISC Valve Unplugged
- Valve clearances - which is better?
- pedals interchangeible
- Radiator Hoses Connections
- motor mounts
- Heater problems
- 12k rebuild tear down
- timing
- New Exhaust
- Stock ct-26 turbo smokes
- Intake advice needed
- Big Prob, Dont know what to do next...
- 1988 turbo supra
- afm or ecu
- ct26 60trim q's
- Fuel Pump Wiring
- Fuel cut without boost leaks?
- Throttle body not closing
- head gasket
- car wont start! need help
- Maxing out the Lex AFM
- Attempting a FFIM ISC question
- Smoke and Idle Problem
- STUMBLING PROBLEMS PLEASE HELP!!!!!
- 7mgte reman'd crank kits
- Are there Getting rid of that throttle assembly ways?
- Ruined my Rare Shift Knob
- broken timing belt pulley, and oil pump pulley
- head bolts and intercooler
- Tough shifting gears under full throttle?
- valvetrain question
- Automatic Transmission Temperature sensor
- Rod Knock?
- leaning out issues please help!
- 7m-gte 1jz help
- Shocks vs Struts????
- walbro pump with out a fpr
- Compression test results!!!
- heating problem!!!
- OK...here's the deal...
- Help with my specific problem
- Help with my specific problem
- How much for new coils?
- Turbo is hot very very hot??
- where is the
- T4 turbo install question
- Well, everything is back in place under the hood...
- What is it?
- boost gauge problem
- spec multidisk clutch
- opinion on turbo
- opinion on turbo
- boost gauge problem
- Causes of Fuel Cut beside boost leaks?
- is the PP trashed--PICS
- fuel cut with BIC exhaust....
- Opinion please
- Head height is 115.65 mm, going to use a stock head gasket..problems?
- greddy profec help
- Brian Cower Cams :: Talk to me about it.
- oil presure
- oil presure
- considering rebuild
- turbo rebuild
- got fuel cut fixed!! but some questions!
- are these good? injectors
- real quick bov help
- should i lower my compression
- Uhh exhaust question *giggles don't flame me*
- Bosch 110 BPV Problem
- Slight surge under hard acceleration
- R154 fill plug?
- New motor won't idle. BC 264 cams?
- USDM 7MGTE to JDM 7MGTE
- SOMEONE PLEASE HELP!!!!
- Power, No power. Repeat. (video)
- Check engine lights SUCK!!!!
- Guaging intrest/worth of a 7m
- aftermarket climate controls
- check engine light when i rev?
- possible boost leak
- Power/Fuel Economy Issue
- Yet another Lex AFM question thread
- 2 in 1
- Gauge Cluster on 7mgte fries by touching it?
- Strategy to Remove C-Clamp?
- Only hitting like 7.5psi of boost.
- BOSCH BPV part number?
- Adjustable cam gears
- Question about parts
- Turbo squelching.
- Auto Shift points
- code 52 without "limp" mode
- Quick cam question
- waterfall sound behind dash??
- how do i position the cps
- Oil cooler position question.....
- lifter shim question
- shifter busing falls into the tranny
- desperatly need guidance on MAF subject, technically
- Clear Corners/Signals
- No more spark?
- turning the crank a bad idea?
- Has anyone ever rebuilt their R154 Tranny?
- so i'm getting a 7mgte engine swap....
- Is .040 TOO much?
- Cluster Help
- garrett gt4082 users
- Questioning my turbo choice...
- Stock oil cooler hose size
- Clutch vibration like its grinding gears....but the gear isnt even engaged????? wtf?
- information overload
- Oil and egt questions
- what do i need for a turbo upgrade?
- what are these for???
- Drilling out the J-tube?
- No Heat!
- Front feed Intake Manifold
- Will adding 550's raise fuel cut?
- trans swaps
- is this a good turbo?
- Stock IC Question
- Car wont turn over.
- code 31 running rich
- Who has a 1j or 2j FFIM on 7mgte engine
- Oil Pump Question
- any idea's??
- Is the flange I need for cat to a 3 in downpipe?
- E-Manage? and HKS Head gasket?
- running so rich it could be a v8
- Engine light when turning up boost????
- Axle Problems?
- are these injectors good
- intake air temp sensor map ecu
- isuzu NPR turbos
- Error code 21, then misfiring and white smoke help
- How much torque should I torque a 2mm HKS headgasket?
- 7m wont start! No crank or click...
- Turbo and turbo elbow
- code 31
- cold starter problem?
- downpipe decision advice
- New Oil pressure sensor location question
- limp mode???
- no spark!!!
- Eagle rod bolt torque
- vsv disconnect