- Archive: MAFT Pro Questions
- Archive: Original MAFT Questions
- VPC/SAFC
- How to: MAFT Pro Boost Control
- How to: MAFT Pro Timing Monitor
- maf translator (not maft-pro or gen2)
- VPC Diagnostics?
- Anyone running MAP-ECU on the 1jz?
- VPC/SAFC-2 and Nitrous
- Archive: AFC/SAFC/II/Neo Questions
- installing different vpc chip
- How to wire AEM uego into maft pro
- Information: Vf
- is e-manage a good choice
- make your own portable power cable?
- VPC with SAFR
- maft translator gen II and msd btm
- When Are Piggy Backs Not Enough?
- Lean Cruse How To?
- VPC Leaning out HELP!
- maft pro not turning on
- VPC
- Mounting the Boost solenoid.
- need to tune my Supra...ON L.A CA
- Super monitor and Maft-pro
- LC1 into the Maft Pro
- maft-pro just to replace afm??
- HKS S-AFC and VF
- Innovate SSI-4 (Good? Bad?)
- maft pro problems
- aem wideband
- maft install?
- Vf clarification
- emanage blue info needed....
- e-manage blue set-up help on a ge
- MAFT PRO and fuel cut
- MAFT Pro Boost Control
- map ecu install on 1jz
- Information: MAFT Pro v4.80 Terms/Definitions/Info
- Information: The Definitive MKIII Supra MAFT Pro Guide
- MAP-ECU
- Open for suggestions
- safc questions
- help
- my setup and how it goes.
- Upgraded to MAFT-Pro 4.80; car runs like crap...
- Apex neo
- mafpro boost help
- piggy back ecu options please....
- The Complete Piggyback Comparison
- safc ground question
- zeitronix and safc wiring help
- SAFC 1 + FCD Wiring ??
- vpc temp sensor
- FCD - good for anything?
- installed maf-basic..."no MAF signal"
- Code 31 using VPC???
- How to tune using every resource of the car?
- Question about F-CON systems
- VPC OP. Out
- SAFC problems
- Code 24 w/maft pro
- MAP ECU and MAP ECU II
- Apex'i Neo vs Greddy E-manage?
- MAFT Pro
- RPM/TACH ECU signal
- SAFC buzzing noise, Help
- new alarm = code 31
- MAPECU running rich
- Largest injectors for piggy back.
- Stand alone timing monitor
- maftpro tipin stumble, 2krpm hickup....
- AEM F/IC
- Help with hks super afr
- safc2 wiring diagram?
- maft basic on 89+ hac sensor?
- neo on a vpc
- maftpro questions
- map ecu 2 or aem ems
- Which is better- MAFT pro or MAP ECU
- Anyone using or interested in Tec 3r or...,
- need tuner help
- Where can i get some info on how to street tune w/ a SAFCII?
- i think i finally decided
- two step
- Maftpro 4.80 working smooth
- hks vpc issuse
- Piggyback EM Question
- maft origonal no maf signal?
- stand alone
- Logging CF% with TunerPro
- Apexi Neo on 1jz
- Lean spike free-reving
- Help with dission about e-manage
- Does it matter if...
- maftpro v4.8 issues
- help on tuning a maftpro in kentucky
- Tuner pro
- MAF-T
- Q: Forcing ECU into Open Loop (7MGE)
- Wideband for map ecu
- need help tunning maft pro
- AEM F/IC
- car wont rev past 2500 rpms??? help fast
- MegaSquirt users
- Questions about AFC's
- Pinout of APEXi PowerFC for non-VVTi 2JZ-GTE? I was sure it connects directly, but...
- 720cc Injectors on Mapecu
- Greddy Emanage Blue Question!!!
- MAFT Pro / LC1 connection problem?
- Maft Pro Software Problem
- please help...
- Quick MapECU question
- Need help with electromotive XDI ignition
- need some help and some advise plz
- Startup problem with maft-pro
- is there a piggyback which can monitor orig. ecu settings?
- bad connection with maft pro
- Maft Pro Boost Pressure Reading
- A couple maft pro problems:
- base map for e-manage
- maf-t pro and safc
- TOMS TEC ECU for 2JZ-GTE
- Perfect Power piggy-back
- Map ecu 2 and boost control
- map ecu 2 two-step video
- Best bang for your buck piggyback
- Issues w/ E-man blue on my 1JZ..
- Maft Pro Help
- Quick EManage Blue question
- PnP harness for the S-AFC II?
- Is it possible to tune a GE AFM with the SAFC?
- how to change your low and mids on maftpro
- help
- SAFC II Tuning Basic
- Where to get PnP harness for Geddy Ultimate
- Greddy "U" Lexus or Stock A.F.M.?
- Alphabet soup instructions
- boost controllers..
- safc test
- maft pro installation help.
- Connecting 6wire LC1 to a MAFT-Pro
- High settings with SAFCII...negatively affecting things?
- Need help instructions for configuring Greddy Rebic LC
- How does SAFCII stores settings in the memory...?
- Tuning Experienced 7m owners
- Piggy back dilema
- GRAY WIRE on maftpro
- 1jz map ecu?
- Eman Ultimate on a 1j ??
- hks pfc f-con question
- 3 Maft Pro questions
- HKS FCON w/ 550cc Rom Plug n Play?
- 550cc map tuned for MAP ECU
- user friendlieness? Maftpro or Map ecu 2?
- Throttle air temp, How can I get a reading on a laptop Program>?
- HKS F-CON Harness
- New MAFTPro 5.03 Install questions
- Mounting Maftpro
- MAF-T pro V 4.40 HELP!!!
- Maft Pro 4.8 upgrade?
- Plumbing boost solenoid for Maft?
- Official emanage ultimate thread
- HKS Fcon Type S
- Possible low MAP reading?
- hks fcon rom
- Aftermarket ecu map tuning?
- mapecu
- Maft Pro initial start up lean!
- Fuel cut with MAFTPRO?
- HKS VPC & GCC Settings
- Greddy "U" Or stock E.C.U. To control timming?
- Help diagnosing 1JZ EMU problems
- Maft Pro timing control now working.
- Stock AFM, removed air screw, Apexi AFC - Who's done it???
- Suggestions for mounting a Maft pro
- I can’t adjust the A/F at idle to keep it at 14.X to 15.X
- S-AFC prolems with diagram
- AFR problems with MAFT pro
- Maft pro tuning question
- SAFC tuning fuel press Q's
- Injector size with S-AFC
- VPC Problem?
- maft pro experts, help on wires and installing
- mapecu2 timing control
- MAFT Basic Revised Instructions
- MAFT Pro display/control box problem(s)?
- Safc install help
- Fuel cut!
- Anyone using emange blue ignition adjustment
- Base Tune MAFT Pro
- 2JZ-GTE with AEM FIC
- MAFT-Pro Tuning Help/Advice (bin & adl supplied)
- New AEM FIC
- Maft Pro help! WTF?
- MaftPro Logviewer on crack - Excel CVS utility included!
- MAFT Pro Boost Selinoid Connections
- 2jzgte Emanage U
- Big Problem with VF Signal on MAFT Pro
- clarification on tuning.
- Innovate LC-1 Help Needed
- Neo Help
- Maft Pro crank but no start
- MAFT and NEO install on 89 7mgte
- Maft Pro 4.8!!
- MAFT Pro or E-manage Ultimate?
- emb software help
- PFC FCON help
- emanage ?
- SAFC low throttle tuning?
- safc neo sensors
- MORE Maft Pro Help
- SAFC II with 550cc on 1JZ?
- Maft-pro and boost cut issues (logs/settings/mods included)
- Maft Pro base tune Help
- vpc sensor voltages
- VE Table on MAFT Pro
- Almost resolved A/F issues,
- has someone ever used this piggyback
- Tuning out stalling problem with SAFC
- Rebic Lc, Wiring diagram or pin out required
- PFC Fcon Harness
- vf reading when in ptt mode
- Maft-pro question
- Looking for info to complete my diy safc.
- MegaSquirtII
- 720cc injectors basemap for a map ecu
- VPC acts as a FCD - HOW?
- map ecu
- hooked up safc, running realy rich
- maftpro hardware!!
- Maft Pro Boost Control Wiring
- "stock" settings for apex'i neo?
- SAFC calculations help...
- maft-pro + 780cc injectors
- Apexi S-ITC questions
- 1jz build with big single turbo and support - What EMU is right for me?
- NEO issue, one pull then no power
- tuning map ecu
- HKS FCON wiring diagram
- maft pro HAC question
- Bad Karman signal output with SAFC Neo
- NEO issues
- Wiring Help w/ PLX-R500 & Maft-Pro
- Piggy newbie
- GReddy Emanage Blue
- EMU controlling meth
- newbie tuning help!!!!
- home-brewed vf meter
- Emanage Ultimate 7MGTE install