? about cam position sensor rebuild/reseal

jetjock

creepy-ass cracka
Contributor
Joined
Jul 11, 2005
Messages
9,439
Likes
1
Location
Redacted per Title 18 USC Section 798
#2
I have. Piece of cake. I reused the gear though because owning a 20 ton press has it merits.

One place to buy the stuff: http://tinyurl.com/yq3tvp

Or you can get it for cheap from the outfits mentioned in 3P's excellent write up.

While you have it out cut a gasket for the CPS so you never have to mess with that O ring again. Might as well replace the cover and gasket too...
 

GrimJack

Administrator
Staff member
Administrator
Authorized Seller
Joined
Dec 31, 1969
Messages
12,377
Likes
0
Location
Richmond, BC, Canada
#3
I did it as well. I had to buy the new gear, because I DON'T own a 20 ton press. It was a stone cold bitch to get out, too, if I had to do it again I might just buy a press!

Other than that, it was simple.
 

89blackturbo

New Member
Authorized Seller
Joined
Jun 10, 2010
Messages
18
Likes
0
Location
Florida
#6
I reused the gear without a press. Just drill the original dowel out, and i forget how i got the gear off. Hammer and a vice I think.
 

tonylr35

New Member
Authorized Seller
Joined
Oct 24, 2011
Messages
4
Likes
0
Location
cumming
#8
Tried to just punch the dowl but no luck. Press looks like the way to go. $180 at Harbor Freight
 

tonylr35

New Member
Authorized Seller
Joined
Oct 24, 2011
Messages
4
Likes
0
Location
cumming
#11
thanx ya'll. Got it done. The dowl did need to get drilled out. I didn't replace the gear. Came out petty easy. My cover also needed replace. I just used the Jetjock's link and got a complete kit from them. $25. Easy