Search results

  1. Zazzn

    Emanage or more needed for hx35?

    I paid 400 + 100 for the new Greddy harness, had plans to put it in my grey 91 but I have a PNP MS3 so that's going in. Say 450, and I can also give you the mod for the timing chip I built.
  2. Zazzn

    Emanage or more needed for hx35?

    I actually have a spare ultimate if you are interested.
  3. Zazzn

    AR5 Trans Take Two: The Solstice Solution

    So here's what I did for my R154 clutch, where the rivets behind the straps are, I drilled it out and tapped it for an m10 bolt and i machined the bolt to fit in the friction surface
  4. Zazzn

    Emanage or more needed for hx35?

    I don't believe anyone will have anything they can provide you. With a custom setup, you will need a custom tune. However, tuning piggybacks are really easy, simply lean or richen until you are good. Timing usually fine because stock computer can pull out timing when knocking but at that low...
  5. Zazzn

    Emanage or more needed for hx35?

    S-AFR can do that alone. I think you have the case of needing someone how knows how to tune the car. Emanage will certainly help, over the S-AFR. It allows for timing adjustment and injector pulse with adjustment so it's far superior to the HKS unit. However even it's over 12 years old now...
  6. Zazzn

    AR5 Trans Take Two: The Solstice Solution

    Bringing this up from the dead. I've been looking at clutch options and I noticed that Spec offers an 800 TQ holding clutch for the Solstice in a single disc bronze material. Got me thinking, does the Solstice pressure plate work at all with the mk3 supra? Excuse my ignorance I haven't done...
  7. Zazzn

    1JZ with 6262 turbo and .58 exhaust housing limit

    complete opposite, you'll be able to control the throttle much more linear. With a .81 it will be an on-off switch frying tires for sure. On my old sp63 on my 7m I used to get 15 PSI in 5th at 3500 rpm with a .58, however then I changed it to a .70 and a .84. The .58 certainly makes the car...
  8. Zazzn

    1JZGTE Haltech ECU install and setup

    Cool who tuned, how much boost seems a little shy on power. Man could have showed you some tricks with the emanage ultimate ;)
  9. Zazzn

    1JZ with 6262 turbo and .58 exhaust housing limit

    If you are pump gas, I doubt you'll see any difference if you are E85, then swap because you get more exhaust flow anyways and you'll jack the boost.
  10. Zazzn

    1JZ with 6262 turbo and .58 exhaust housing limit

    .58 will hurt top end at the upper limits but less then you would think. Maybe 100 WHP off the top vs .58 / 1.0 AR
  11. Zazzn

    Engine dies after half second start up E MANAGE ULTIMATE

    I had to change my temp sensor to ty2 for my 2jz-gte to read correctly.
  12. Zazzn

    Emanage users, E85 blending with stock computer + emanage!

    Check this out. I did a write up here. https://www.supraforums.com/forum/showthread.php?1113165-E-manage-Ultimate-guide-to-Flex-fuel-blending!
  13. Zazzn

    Passing of a member. Flateric.

    Terrible news!
  14. Zazzn

    Lexus/Toyota "Supra"

    I'm sorry, I'm completely dissatisfied with absolutely everything I've heard about the mk5. What a disgrace to bring it back in such a way... Tetsuya tada, has disgraced the name IMO. No manual, not even a Toyota engine. Geeze this is so bad it's funny. I expect some nasty reliability issues...
  15. Zazzn

    lexus afm 550cc. Really bad idle and erratic fuel cut

    I had a HKS S_AFR as well back in the day, but I don't remember the interface well enough to tell you how to tune. I want to clear up a few things here. The WHOLE point of a Lexus AFM and 550's is because the Lexus AFM allows 30% more air without being metered. To make up that fuel you add...
  16. Zazzn

    lexus afm 550cc. Really bad idle and erratic fuel cut

    very much sounds like a dead time mismatch
  17. Zazzn

    Supramania's Elite Engine bay Thread...ZERO progress pics.

    ^ no doubt, just been a long time!
  18. Zazzn

    Supramania's Elite Engine bay Thread...ZERO progress pics.

    Wow last yellow supra I saw was the Lamdarossa
  19. Zazzn

    lexus afm 550cc. Really bad idle and erratic fuel cut

    BOV will make more flutter noises as you raise boost as naturally there is more air and it's stock it's not exactly the largest BOV for moving air. Even with the Lex AFM screw completely out I didn't have lean issues at idle because the stock computer can adjust up to 30% fuel trims if the...
  20. Zazzn

    lexus afm 550cc. Really bad idle and erratic fuel cut

    Hello, If you are seeing FCO at 5 PSI you definitely have a leak somewhere in the intercooler system. the turbo has to be pushing ALOT of air through the AFM to show 1500HZ -1700HZ of which will cause FCO. If your idle is garbage on the new injectors it could be the stock ECU on these injectors...