Recent content by suprachris

  1. S

    Fastest mk3 1jz with a th400

    Do I have the best et in a mk3 1jz with a th400 trans? Car 375. Lmk video is to large to attach.
  2. S

    Up to date 1jz mk3 1/4 mile times

    I'm looking for information on where to go for updated 1jz mk3 1/4 mile times. Yes I saw the list on here, not sure how current it is. Any guidance would be appreciated.. Thank you.
  3. S

    ***SM member 1/4 mi. times list***

    1988 mk3. Stock block 1j. 264 cams, th400, e85, s362 on wastegate pressure of 19 psi. Third run on this set up. 11.44 @ 121. On the limiter the last 75 foot. Right lane. Video on my Facebook. Christopher beard
  4. S

    1j soarer auto engine and trans. Mk3 chassis

    I figured it out.. the black nsw wire is a ground.. not a power wire.. the trc computer didn't do a damn thing. It works. Flips a check engine lamp when boost launching, it was removed. I still get a code for rpm signal wire. Haven't been to worried about it yet. Buy will look further into...
  5. S

    mk3 1jzgte wiring questions

    During the whole process of swapping my 1j, I never knew about this site. Maybe I can now figure out why my neutral safety switch isn't working as it should.. thanks
  6. S

    1j soarer auto engine and trans. Mk3 chassis

    I should have started a build thread when I started the swap.
  7. S

    1j soarer auto engine and trans. Mk3 chassis

    I would load a picture of it on here, but my phone won't let me, and or Idk how.
  8. S

    1j soarer auto engine and trans. Mk3 chassis

    Thanks for the help. I just looked at my 1j harness and there is a plug kinda like that. I did some digging, the only thing I can find that plugs into mine is the trc computer. Idk if it does the same thing or not but I ordered one.
  9. S

    electrical help in a few matters

    When I did my swap here in the last three months I ran into this issue.. in my case, the ground for the gauge cluster was wrong. It made my gauges peg/max out. I have 86.5 turbo chassis harness. All my gauges now work except the speedometer.. my car is a 1jz no. Vvti auto.. make sure you have a...
  10. S

    1j soarer auto engine and trans. Mk3 chassis

    Didn't run it tonight. I did however get the radiator and fans mountermd. Trans cooler mountermd and power steering ran. Installed the new center support bearing, added coolant.. I'll bleed it tomorrow after I hook up the fan controller.. I did how hmever notice my cheap cx racing bov has two...
  11. S

    1j soarer auto engine and trans. Mk3 chassis

    Pretty much. I'll look into the iac an see if it's all gummed up.. I forgot I had the same issue on the 7mgte. Maybe I'll finish putting my 3 core radiator in tonight so I can run it and check for vac leaks..
  12. S

    1j soarer auto engine and trans. Mk3 chassis

    You know I'm not sure. I know when I pulled the 7mgte auto out years ago it was only one ecu labeled a/t now I believe there was one for cruse and or abs. But it's been 8 years since I've don't that.. I don't remember.. I tried to find info online but no luck yet.. I could have a vacuum leak, I...
  13. S

    1j soarer auto engine and trans. Mk3 chassis

    Car also came with head light sprayers, adjustable tems. So someone could have added all this idk. But I doubt it.
  14. S

    1j soarer auto engine and trans. Mk3 chassis

    My car is a factory turbo automatic chassis.. I personally have owned this car since 60k miles..ten plus years. the gauge cluster is still the turbo auto gauge cluster.. also I'm running the 1jz auto ecu. The Trans shifts fine and kicks down like it should. Now I didn't know there was a...
  15. S

    1j soarer auto engine and trans. Mk3 chassis

    I'm having a few issues.. I have a 1jz auto out of a soarer. I have it up and running/driving. My tach is not correct, says red line is 3400 rpm. Also when I shift front park to neutral it dies also from drive to neutral it dies.. I can't seam.to figure this out. I have checked and rechecked the...