SGM's latest activity
-
SSGM reacted to wisetechscottt's post in the thread Tacho/Igniter Voltage - Want to get stock tach to work! with
Like.
So after a lot of reading and research I figured it out and now have the factory tachometer working without the use of an igniter... -
SSGM replied to the thread No fuel level guage.Mine was also stuck at the dead bottom after sitting for 10 years. I took some plumbing flux in gel form to it, let it sit for a couple...
-
SSGM replied to the thread Chronicling My 86.5 Restoration.I took the sensors out of the housing to test them, boil some water and check resistance as temperature goes up. There's probably an...
-
SWell if you look at the ignitor circuit, each ignition event sends a signal back to the dash. So 6 signals = 1 rpm. I dont believe...
-
SSomeone did this with an AEM unit. Their post here...
-
SSGM replied to the thread Tacho signal - what does it expect?.That makes sense, so it's a low side switch what I need to configure the tach output as. I'll see what I can do, thanks!
-
SSGM replied to the thread Chronicling My 86.5 Restoration.They're on the thermostat housing The 1-wire perpendicular to the power steering reservoir is for the dash, the two wire one next to it...
-
SSGM replied to the thread Chronicling My 86.5 Restoration.It's what I figured would be a spring to keep the rotor pushed against the plunger assembly. Mine went right at the very top of the...
-
SSGM replied to the thread Tacho signal - what does it expect?.Hopefully they'll chip in then! These cars are very rare around here, and I can't imagine someone'll let me rock up to their place, tear...
-
SMorning, I'm wrapping up a Speeduino conversion on my 86.5 turbo manual, and the only thing left to get working on the factory...