Recent content by HKS_TRD

  1. H

    poly subframe bushings kit

    Just sent an email
  2. H

    poly subframe bushings kit

    Hi Ronnie, have you got an email address I can reach you on, was hoping to get these bushes sorted soon Cheers Dan
  3. H

    poly subframe bushings kit

    Thanks Ronnie Going to a different supplier was a bit of a fail on their part it seems based on my experience. If you want to follow up via PM I'd like to order bushes for the suprasport traction rods anf bushes for the camber arms, all in red. BTW I just installed the rear subframe bushes I...
  4. H

    poly subframe bushings kit

    I doubt the design of the arm would have changed, was the bush you made for them different to the bush for the standard arm? I bought mine years ago and installed them but haven't driven the car yet. When I removed them to swap to a strengthened subframe I discovered the bushes had gone brittle...
  5. H

    poly subframe bushings kit

    I need red bushes for the camber arms and also the traction arm/strut rod if it can be confirmed they fit the suprasport/lipp arms. From a quick measurement it seems the OD for the bush in the lipp arm is 37mm is that what the bush you make for the standard arm is?
  6. H

    poly subframe bushings kit

    Ronnie, do you make a bush which fits the LIPP/Suprasport stainless traction arm? On that note does it take the same bush as the standard traction arm?
  7. H

    Fitting Work Equip wheels with a big brake kit

    What size and offset are your wheels and did you find out which disk they are, A or R? What calipers are you running?
  8. H

    Supra Dynasty The Saving, Death & Resurrection of My A70 (V-Mount)

    What thread size did you tap into the side of the motor, do you have any close up pics of the adapter set-up?
  9. H

    Ridiculous 1000HP 7M Street MK3 Build

    I like your new veneer front subframe, very swish
  10. H

    What did you do to your supra today? Pics

    Where did you get the upper ball joints from, I thought the only way to change them was to replace the entire upper arm
  11. H

    Hi from Australia

    Hi John Welcome to the forum, great to hear the other GroupA Supras are intact and look forward to following their progress now that they are in your hands
  12. H

    Supra Dynasty The Saving, Death & Resurrection of My A70 (V-Mount)

    Enjoying the updates Keen to see the solution for adapting the water pump inlet to a -20 fitting Keep up the great work
  13. H

    poly subframe bushings kit

    Hi Ronnie Thanks for the quick reply. Yep I kept the outer shell in the lower arm I'm putting the bushes in Dan
  14. H

    poly subframe bushings kit

    Hi Ronnie Couldn't find another thread so asking in here. With the upper arm bushes besides the tubes you supply, are any additional washers needed for the front arms, and ditto for the rears. Also same question for front lower control arm Thanks Dan
  15. H

    ~* Purchased a 1992 Turbo Black / Shadow Grey Hardtop *~ Pre Build Help WELCOMED!

    Nice work to not only find a very desirable variant of the MKIII but one that going by the pics is in very nice condition. Looking forward to watching this build unfold. For the HG 9 times out of 10 the 2mm is the go. For a high hp build you'd want to avoid a thicker hg as it becomes a weak link...