debrucer's latest activity
-
i beleive it was from 1996 and up that cars switch to obd-2 systems, and the mk3 went up to 1992 so it had the obd1 set up which is the... -
Depending on what year you got your 2j from, it may or may not have an OBDII port, and even then, are those normally included with a...
-
so I take it your running a 2jz-ge? and I was going to go with VF1 bridged plan but how did you wire a DLC into the PCM? so you could...
-
That was what I needed.
-
I would suggest shimming those pickups so they are parallel with the CPS rotor. Yours is noticeably slanted. Some photos here...
-
gap specs are here. http://www.cygnusx1.net/Supra/Library/TSRM/MK3/manual.aspx?Section=A&P=14
-
Cardone...:mad: I won't go there again...
-
Set the air gaps according to the TSRM.
-
Mine is on the same R12 charge since 1997 when I had the TXV valve replaced under a recall. That 22 years without servicing!! And I...
-
Those cheap machines are firmly in the hobby department (FDM - fused deposition modeling, printing primarily ABS and PLA) at the moment...
-
You might consider replacing a few friends while you're at it. Good Luck!
-
Is the pump not working? If you're not sure, you can use a jumper wire in the diag block between B+ and Fp pins. You should be able to...
-
Tweak did my 1jZ harness and didn't put a diagnostic plug on. Only a two pin plug to check codes. Mine was new without a core.
-
debrucer replied to the thread 7mgte Wiring Harness.I wasn't aware they had one. The 7mgte listing on their site wasn't too informative and over the years they've "stopped" making these...
-
I am kinda surprised at the price as well when I first saw it plus I do like the OEM replacement connectors they offer. Sorry to hear...