Recent content by blk92suprat

  1. blk92suprat

    Updating Fuel System

    I will prep the block. I have Titan mhg and arp studs on the way.
  2. blk92suprat

    Updating Fuel System

    I'm not sure what you mean by removing load signal.
  3. blk92suprat

    Updating Fuel System

    Which lapping plate is recommended?
  4. blk92suprat

    Updating Fuel System

    I didn't perform a leak down test. However the bubbles at the rad cap while idling tells me what I need to know. I was just happy to see the compression numbers as good as they were. I have a 2 foot straight edge accurate to .002. Also going to try the 3m bristle, the white one which is soft...
  5. blk92suprat

    Updating Fuel System

    Sorry for the delay, I have been so busy these days Supra was on the back burner for weeks. So after I replaced the coolant bypass hose and ecu coolant probe the problem continued. I then with new hks temp sensor, plugged my iat port and drilled and tapped a few inches further from methanol...
  6. blk92suprat

    Door Solenoid trigger

    Mine had a broken extension spring. Pull the door panel off and see if yours is still there. Likely its a mechanical, not electrical issue sounds like.
  7. blk92suprat

    Updating Fuel System

    Well I got everything replaced but battery is now dead after sitting. I have a slow drain that I can't seem to locate. Charging it up over night and we'll see what happens tomorrow.
  8. blk92suprat

    Methanol Injection

    Thanks for your input. I'd imagine it be efficient to around 30psi.
  9. blk92suprat

    Updating Fuel System

    Update: I noticed coolant leak at the small bypass hose from water housing to block. Pulled the cps and water housing off. While I had these parts out, I replaced the hose, water housing gasket, thermostat, thermostat gasket and ecu coolant sensor. Still waiting on coolant gauge sender and...
  10. blk92suprat

    Updating Fuel System

    Injectors will follow if issue continues.
  11. blk92suprat

    Updating Fuel System

    I have ordered a new vpc temp probe as well as ecu coolant probe. Lets see if this solves the issue. The methanol may have damaged the vpc temp probe. Ill swap this one first and see what happens. If that is the issue I will have to change the location.
  12. blk92suprat

    Updating Fuel System

    Injectors were purchased probably 10 years ago. Had them out 8 months ago and put in new orings and grommets. Walbro fuel pump must be around 10 years too. Time for replacements?
  13. blk92suprat

    Updating Fuel System

    How can I verify if the IAT and MAP sensors are functioning properly? Even if I have to manually tune safc for summer and winter tunes, does the leaning afr's with colder ambient temps (and inability to add additional fuel with safc) imply my injectors are running out of breath?
  14. blk92suprat

    Updating Fuel System

    This will be a branched thread off of my Methanol thread. http://www.supramania.com/forum/threads/methanol-injection.247767/ Quick backround: 7mgte 61mm turbo hks vpc 550 chip safc2 550cc injectors walbro 255 adj. fpr base pressure 32 psi with vacuum. Here is my dilemma leading me to think I...
  15. blk92suprat

    Methanol Injection

    Jay, I got the wiring all figured out. Made a call to Snow Performance to confirm everything. No need for you to take your time to check out your wiring but I do appreciate it sir. I have my solenoid right after the pump and check valve closer to nozzle. Still need a few more test drives...