Measuring How much was Taken Off Block and Head
- Thread starter JT87NA
- Start date
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
JT: With any luck my new head will be here today so I'll be able to give you that measurement, as for the block not sure if I've ever seen specs for deck height! (Usually measured from the Main bearing saddle to the deck)
IJ. said:JT: With any luck my new head will be here today so I'll be able to give you that measurement, as for the block not sure if I've ever seen specs for deck height! (Usually measured from the Main bearing saddle to the deck)
Someone said it was 235.00 mm from the middle of the crank or something like that, what type of measurement tools would I need to measure both the head and block?
JT: New head is 116mm thick.
My junk head has .3mm off and Allan's junker we cut up has .6mm off!
My junk head has .3mm off and Allan's junker we cut up has .6mm off!
IJ. said:JT: New head is 116mm thick.
My junk head has .3mm off and Allan's junker we cut up has .6mm off!
Thanks alot IJ you are the man!
Last edited:
You seal a piece of perspex to the head over the combustion chamber with a small hole in the middle then fill it from a graduated container to find out how much it holds.
7m's I believe are 40cc chambers.
No probs with the newb questions it's better to ask!
7m's I believe are 40cc chambers.
No probs with the newb questions it's better to ask!