Sorry if this has been asked/answered before, but I searched with no luck.
I will hopefully be assembling my block some time this week and had a question about the thrust washers I just bought. The crank has been cut .010" (.25mm) on the main and rod journals. I purchased a set of king engine bearings and the mains and rods are .010" oversized but the thrust washers are listed as standard. My questions is should the thrust washers also be .010" oversized? This may be terribly obvious, but I don't have access to my block right now so I can't go check. Thanks.
Andy
I will hopefully be assembling my block some time this week and had a question about the thrust washers I just bought. The crank has been cut .010" (.25mm) on the main and rod journals. I purchased a set of king engine bearings and the mains and rods are .010" oversized but the thrust washers are listed as standard. My questions is should the thrust washers also be .010" oversized? This may be terribly obvious, but I don't have access to my block right now so I can't go check. Thanks.
Andy
